Ê Remove the two screws (see circles).
Ê Disconnect the connector card from the SAS expander board.
7.3.5.4 Installing the new connector card
Figure 63: Removing the connector card
Ê Match the two screw holes of the connector card with the holes in the
expander holder.
Ê Fasten the pre-mounted expander board with two screws on the expander
holder (see circles).
7.3.5.5 Concluding steps
Ê "Installing the fan box" on page 156
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling BitLocker functionality" on page 92
To Next Page
Loading...
