16.5 Minimum startup configuration
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Setting Status Description
1
JP1
JP2
PWD CLR/
BIOS-RCVR
Default: Password delete and
Recovery BIOS options disabled
Password skip enabled
This jumper setting will
permanently delete the current
BIOS password and apply default
BIOS settings.
Recovery BIOS enabled
3JP3
BIOS Flash
Write Protect
Default
Flash write protect enable
Field Replaceable Unit
(FRU)
Component Notes
System board no TPM, UFM or expansion cards installed
CPU with CPU heat sink
1 memory module installed in DIMM slot 1A
Table 5: Minimum startup configuration - components
To Next Page
Loading...
