Fujitsu PRIMERGY RX2540 M1 - Removing Riser Module 2 (FL); Preliminary Steps; Removing the FBU

230 Upgrade and Maintenance Manual RX2540 M1
Expansion cards and backup units
Ê "Enabling BitLocker functionality" on page 92
9.6.4 Removing riser module 2 (FL)
9.6.4.1 Preliminary steps
Ê If applicable, "Locating the defective server" on page 51
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Shutting down the server" on page 53
Ê If applicable, remove all external cables from the expansion card to be
removed.
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
Ê If applicable, disconnect internal cables from the GPGPU card.
9.6.4.2 Removing the FBU
Ê If applicable, remove the FBU as described in section "Removing the FBU
with the holder" on page 221.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver