Fujitsu PRIMERGY RX2540 M1 - Removing the Slot Cover from the Riser Card Holder

RX2540 M1 Upgrade and Maintenance Manual 211
Expansion cards and backup units
9.6.1.2 Removing the slot cover from the riser card holder
Figure 113: Removing the slot cover from the riser card holder
Ê Remove the screw (see circle).
Ê Remove the slot cover.
V CAUTION!
Take care that the EMC spring remains in its place.
V CAUTION!
Keep the slot cover for further use.
Always replace slot covers into unused PCI slot openings to comply
with applicable EMC regulations and satisfy cooling requirements.