Fujitsu PRIMERGY RX2540 M1 - Removing the UFM; Concluding Steps; Replacing the UFM

RX2540 M1 Upgrade and Maintenance Manual 371
System board and components
14.3.2.2 Removing the UFM
Figure 253: Removing the UFM (A)
Ê Remove the nylon screw on the defective UFM.
Ê Disconnect and remove the defective UFM.
Ê The UFM spacer remains on the system board.
14.3.2.3 Concluding steps
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling BitLocker functionality" on page 92
14.3.3 Replacing the UFM
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 5 minutes
Tools: – Phillips PH0 / (+) No. 0 screw driver
– combination pliers and flat nose pliers