Fujitsu PRIMERGY RX2540 M1 - Concluding Steps; Software Configuration

RX2540 M1 Upgrade and Maintenance Manual 369
System board and components
Figure 252: Installing the UFM
Ê Connect the UFM to the system board, snapping in the UFM spacer.
14.3.1.3 Concluding steps
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê "Enabling BitLocker functionality" on page 92
14.3.1.4 Software configuration
In order to setup the ESXi configuration, the VMware ESXi Recovery Tools CD
is required. An ISO image of the CD is available from the Fujitsu service
partners portal at the following https address:
https://globalpartners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/
Pages/default.aspx.
Ê Sign in and choose your PRIMERGY server.
Ê Select the Software & Tools Documentation category.