Fujitsu PRIMERGY RX2540 M1 - Connecting a Battery Backup Unit to the Expansion Card; Concluding Steps; GPGPU Cards in Riser Modules (FL); Installing a GPGPU Card in Riser Module 1 (FL)

210 Upgrade and Maintenance Manual RX2540 M1
Expansion cards and backup units
9.5.6.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 237.
9.5.6.6 Concluding steps
Ê "Reassembling" on page 61
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling replaced components in the system BIOS" on page 86
Ê If applicable,"Updating RAID controller firmware" on page 81.
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê "Enabling BitLocker functionality" on page 92
9.6 GPGPU cards in riser modules (FL)
9.6.1 Installing a GPGPU card in riser module 1 (FL)
9.6.1.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Disabling SVOM boot watchdog functionality" on page 70
Ê "Shutting down the server" on page 53
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver