Fujitsu PRIMERGY RX2540 M1 - Removing the Defective System Board

RX2540 M1 Upgrade and Maintenance Manual 401
System board and components
14.7.2 Removing the defective system board
Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section "Removing processor heat sinks" on page 311
I Leave the processor on the defective board for now.
– Memory modules: see section "Removing memory modules" on
page 282
I Ensure to take note of the memory modules’ mounting positions
for reassembly.
– Expansion cards: see section "Removing expansion cards" on page 181
I Ensure to take note of the controllers’ mounting positions and
cable connections for reassembly.
– UFM: see section "Removing the UFM" on page 370
– DynamicLoM: module see section "Removing the DynamicLoM module"
on page 260 or the three screws that are installed in place of the LoM
module.