Fujitsu PRIMERGY RX2540 M1 - Installing the FBU (Riser Module 2); Concluding Steps; Ê Reassembling

RX2540 M1 Upgrade and Maintenance Manual 229
Expansion cards and backup units
9.6.3.11 Installing the FBU (riser module 2)
Figure 134: Installing the second FBU with the holder
Ê Install the second FBU as described in section "Installing the FBU" on
page 216.
Ê Connect the FBU cable to the RAID controller.
Ê Route the cables as shown.
9.6.3.12 Concluding steps
Ê "Reassembling" on page 61
Ê If applicable, connect all external cables to the expansion card.
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê If applicable, "Updating RAID controller firmware" on page 81.
Ê If applicable, "Enabling Option ROM scan" on page 82.
Ê "Enabling SVOM boot watchdog functionality" on page 86