Fujitsu PRIMERGY RX2540 M1 - Replacing the Heat Sink (FL); Removing the Rear Cover (Riser Module 2); Removing the Slot Cover (Riser Module 2); Installing the Riser Module 2 (FL)

226 Upgrade and Maintenance Manual RX2540 M1
Expansion cards and backup units
9.6.3.6 Replacing the heat sink (FL)
Ê Replace the standard processor heat sink with the processor heat sink for
GPGPU as described in section "Replacing processor heat sinks" on
page 312.
9.6.3.7 Removing the rear cover (riser module 2)
Ê Remove the rear cover as described in section "Removing the rear cover
(riser module 2)" on page 198.
9.6.3.8 Removing the slot cover (riser module 2)
Ê Remove the slot cover as described in section "Removing the slot cover
(riser module 2)" on page 199.
9.6.3.9 Installing the riser module 2 (FL)
Figure 129: Position of the recesses
Ê Take note of the two recesses (see circles).