Fujitsu PRIMERGY RX2540 M1 - Replacing the Front USB3.0 Connector; Preliminary Steps; Removing the Front Panel Module; Removing the Front USB3.0 Connector

RX2540 M1 Upgrade and Maintenance Manual 355
Front panel and external front connectors
13.4.3 Replacing the front USB3.0 connector
13.4.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Locating the defective server" on page 51
Ê "Shutting down the server" on page 53
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
Ê "Removing the fan box" on page 154
13.4.3.2 Removing the front panel module
Ê "Removing the front panel module" on page 344
13.4.3.3 Removing the front USB3.0 connector
Ê "Removing the front USB3.0 connector" on page 354.
13.4.3.4 Installing the new front USB3.0 connector
Ê Install the new front VGA connector as described in section "Installing the
front USB3.0 connector" on page 350.
13.4.3.5 Re-installing the front panel module
Ê "Removing the front panel card" on page 342.
13.4.3.6 Concluding steps
Ê "Installing the fan box" on page 156
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: hexagonal SW5