Fujitsu PRIMERGY RX2540 M1 - Installing an Expansion Card; Connecting Cables to the Expansion Card; Connecting a Battery Backup Unit to the Expansion Card; Concluding Steps

RX2540 M1 Upgrade and Maintenance Manual 185
Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing a slot bracket" on
page 171.
9.4.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 166.
Ê "Installing expansion cards" on page 178.
Ê If applicable, "Installing SFP+ transceiver modules" on page 172.
9.4.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 411.
9.4.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 237.
9.4.3.6 Concluding steps
Ê "Reassembling" on page 61
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling replaced components in the system BIOS" on page 86
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section "Looking up changed
MAC / WWN addresses" on page 93.
Ê If applicable,"Updating RAID controller firmware" on page 81.
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê "Enabling BitLocker functionality" on page 92