Fujitsu PRIMERGY RX2540 M1 - Installing an Expansion Card in a Riser Module; Installing the Dummy Cover to Riser Module 2 (HL)

RX2540 M1 Upgrade and Maintenance Manual 197
Expansion cards and backup units
9.5.3.3 Installing an expansion card in a riser module
Ê Install the expansion card as described in section "Installing an expansion
card in a riser module (HL)" on page 187.
9.5.3.4 Installing the dummy cover to riser module 2 (HL)
Figure 103: Installing the dummy cover to riser module 2
Ê Position the dummy cover.
I Make sure that the bracket of the riser card holder is positioned
outside the dummy cover (see closeup).
Ê Fasten the dummy cover with two screws (see circles).