Fujitsu PRIMERGY RX2540 M1 - Nic Configuration; Boot Configuration; Port Configuration

258 Upgrade and Maintenance Manual RX2540 M1
Expansion cards and backup units
Ê Press the [Ctrl] + [P] keys during POST phase.
Ê Select Controller #1 Configuration and press the [Enter] key.
Controller Model: OCI14000-LOM
Firmware Version: 10.2.265.3
IPL Version: LS2FFTE0
Multichannel: DISABLED
Personality: NIC
SRIOV: DISABLED
RoCE Profile : RoCE-1
Ê Press the[F6] key to continue
Port Selection Menue
Ê Select Controller #1 - Port #1: Bus xx Dev 00 and press the [Enter] key.
1. NIC Configuration
2. Boot Configuration
3. Port Configuration
Ê Select Boot Configuration and press the [Enter] key.
PXE Boot: ENABLED
Ê Press the [ESC] key twice to get back to the Port Selection Menu.
Ê Select Controller #1 - Port #2: Bus xx Dev 04 and press the [Enter] key.
1. NIC Configuration
2. Boot Configuration
3. Port Configuration
Ê Select Boot Configuration and press the [Enter] key.
PXE Boot: ENABLED
Ê Press the [ESC] key twice to get back to the Port Selection Menu.
Ê Press the [F7] key to save the settings.
Ê Press the [Y] key to exit the Utility menue.
Ê Start BIOS Configuration Utility