Fujitsu PRIMERGY RX2540 M1 - 9.9 External COM1 connector

RX2540 M1 Upgrade and Maintenance Manual 265
Expansion cards and backup units
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
Ê Configuration of network settings should be performed by the customer.
9.9 External COM1 connector
9.9.1 Installing the external COM1 connector
9.9.1.1 Preliminary steps
Ê "Disabling SVOM boot watchdog functionality" on page 70
Ê "Shutting down the server" on page 53
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tool: – flat screw driver
– hexagon screw driver 5 mm