Fujitsu PRIMERGY RX2540 M1 - Removing the FBU Holder from the Air Duct

RX2540 M1 Upgrade and Maintenance Manual 245
Expansion cards and backup units
9.7.3.2 Removing the FBU holder from the air duct
Figure 148: Removing the FBU holder from the air duct
Ê Lift up the green locking handle on the FBU holder (1) while sliding the FBU
holder to the left as far as it will go (2).
I After that, the hooks on the air duct will rest in the wide ends of the
keyhole slots on the holder.
Ê Lift the FBU holder from the air duct (3).
Ê Pull the FBU cable through the gap in the air duct.