Fujitsu PRIMERGY RX2540 M1 - Installing the Front USB3.0 Connector; Re-Installing the Front Panel Module; Concluding Steps

352 Upgrade and Maintenance Manual RX2540 M1
Front panel and external front connectors
13.4.1.4 Installing the front USB3.0 connector
Figure 238: Fasten the front USB3.0 connector
Ê Fasten the front USB3.0 connector with two screws.
V CAUTION!
Do not fasten the screw too firmly (screw torque 0.4 Nm)!
13.4.1.5 Re-installing the front panel module
Ê "Removing the front panel card" on page 342
13.4.1.6 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 156
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling BitLocker functionality" on page 92