Fujitsu PRIMERGY RX2540 M1 - Removing Riser Module 2 (HL); Preliminary Steps; Removing the Riser Module 2 (HL)

202 Upgrade and Maintenance Manual RX2540 M1
Expansion cards and backup units
Ê If applicable, "Updating RAID controller firmware" on page 81.
Ê If applicable, "Enabling Option ROM scan" on page 82.
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê "Enabling BitLocker functionality" on page 92
9.5.4 Removing riser module 2 (HL)
9.5.4.1 Preliminary steps
Ê If applicable, "Locating the defective server" on page 51
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Shutting down the server" on page 53
Ê Remove all external cables from the expansion card to be removed.
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
Ê If applicable, disconnect internal cables from the expansion board.
9.5.4.2 Removing the riser module 2 (HL)
Ê If applicable, "Removing an SFP+ transceiver module" on page 175.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver