4.4 Getting access to the component
V CAUTION!
●
Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top / side cover is removed.
●
For further safety information, please refer to chapter "Important
information" on page 39.
4.4.1 Extending the server out of the rack
V CAUTION!
●
Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
●
Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
●
For further safety information, please refer to chapter "Important
information" on page 39.
To Next Page
Loading...
