Fujitsu PRIMERGY RX2540 M1 - Installing the Heat Sink

310 Upgrade and Maintenance Manual RX2540 M1
Processors
11.5.2.2 Installing the heat sink
Figure 200: Installing the heat sink
Ê Carefully seat the heat sink on the four threaded holes as shown (see close-
up).
V CAUTION!
– Ensure that the screws on the heat sink are properly seated on the
threaded holes.
– Ensure that the heat sink cooling fins match the direction of the
airflow!
Ê Fasten the four captive screws on the heat sink in a crossover pattern
(screw torque: 1.0 Nm, not applicable for the Japanese market) (1-4).