Ê "Shutting down the server" on page 53
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
9.8.4.2 Removing the DynamicLoM module
Ê "Removing the DynamicLoM module" on page 260
9.8.4.3 Installing the DynamicLoM module
Ê "Installing the DynamicLoM module" on page 256
9.8.4.4 Concluding steps
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 93.
Ê "Updating the NIC configuration file in a Linux environment" on page 90
Ê "Configuring LAN teaming" on page 97
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê Start Emulex PXESelect Utility
Ê Press the [Ctrl] + [P] keys during POST phase.
Ê Select Controller #1 Configuration and press the [Enter] key.
Controller Model: OCI14000-LOM
Firmware Version: 10.2.265.3
IPL Version: LS2FFTE0
Multichannel: DISABLED
Personality: NIC
SRIOV: DISABLED
To Next Page
Loading...
