9.6.4.7 Insert the riser module 2 (FL)
Optionally you can install the riser module. In this case proceed as follows:
Ê Install the riser module as described in section "Installing the riser module 2
(FL)" on page 226.
9.6.4.8 Installing the system air duct
I If no GPGPU card is installed in riser module 2 you have to order a new
air duct to direct the airflow directly onto the CPU heat sinks and memory
slots.
Ê Install the system air duct as described in section "Installing the system air
duct riser module 1" on page 218.
9.6.4.9 Concluding steps
Ê "Reassembling" on page 61
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
Ê "Enabling BitLocker functionality" on page 92
9.6.5 Replacing GPGPU cards in riser modules
9.6.5.1 Preliminary steps
Ê If applicable, "Note on network settings recovery" on page 184.
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Disabling SVOM boot watchdog functionality" on page 70
Ê "Locating the defective server" on page 51
Ê "Shutting down the server" on page 53
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
