Ê If required, install the rack mounting bracket and rack system into the rack
as described in the Rack Mounting Kit - RMK-F1/F2 DROP-IN Quick
Release Lever (QRL)" Mounting Instructions.
I The printed poster is contained in the rack mounting kit.
Figure 9: Mounting the server onto the rack rails
Ê Fully extend the telescopic rails until they lock in place (1).
Ê At a slight angle, lower the server onto the rear mounting point on the
telescopic rails (2).
Ê Fold down the server (3). Ensure that all six rack mounting bolts are properly
seated in the mounting points on the telescopic rails (4) and that the locking
bars engage (5).
To Next Page
Loading...
