Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page
49.
▶
If the HDD module to be removed is combined into a RAID array, please
proceed as follows:
RAID level Procedure
RAID 0
CAUTION
RAID 0 provides no data redundancy.
In case of an HDD module is defect, all
data are lost!
RAID 1
RAID 5
Removing an HDD module from a RAID 1 or RAID
5 array will not result in data loss. However
, the
removed drive needs to be replaced immediately
by an HDD module of the same or larger capacity.
After replacing the HDD module, RAID
rebuild will be performed as a background
process, see "Performing a RAID array
rebuild" on page
108.
In order to permanently remove an operational HDD module that is part of a
RAID array from the server
, you first need to delete the array using iRMC S6
web interface.
CAUTION
All data on all HDDs in the array will be lost when deleting the RAID
array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see the "iRMC S6 - Web Interface" user
guide.
Removing a 3.5-inch HDD module
▶
Pinch the green locking clips and open the locking lever
, see Figure 64.
▶
Pull the HDD module out a few centimeters.
Hard disk drive (HDD) / solid state disk (SSD)
154 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
