Some SSDs / PCIe SSDs have a write life (limited life component). Ask
the customer to check the write status before replacing the spare part. If
the product has reached the end of its life, ask the customer to purchase
it again.
For Japan, refer to the following:
https://jp.fujitsu.com/platform/server/primergy/support/parts/#parts2
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Locating the defective component" on page 48.
Removing the defective 3.5-inch HDD module
▶
Remove the HDD module, see "Removing a 3.5-inch HDD module" on
page 154.
▶
If the new HDD module does not have an installation frame, replace the
installation frame, "Handling HDDs or SSDs without installation frame" on
page 138.
Installing the new 3.5-inch HDD module
▶
Install the HDD module, see "Installing a 3.5-inch HDD module" on
page 152.
Concluding steps
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see "Performing a RAID array
rebuild" on page 108.
▶
For a spare disk, verify that it is set to Hotspare in iRMC S6 web interface.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 157
To Next Page
Loading...
