Figure 67: Removing the 10x 3.5-inch HDD backplane
▶
Release the eight screws (see circles).
▶
T
ake out the HDD backplane at a slight angle.
Installing the new 10x 3.5-inch HDD backplane
Figure 68: Installing the 10x 3.5-inch HDD backplane
▶
Insert the HDD backplane into the chassis.
▶
Fasten the eight screws (see circles).
▶
If applicable, install the internal RAID riser module, see "Installing an
internal RAID riser module" on page
297.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 159
To Next Page
Loading...
