Installing the new 12x 3.5-inch HDD backplane
Figure 71: Installing the 12x 3.5-inch HDD backplane
▶
Insert the HDD backplane into the chassis.
▶
Fasten the nine screws (see circles).
▶
Install the internal RAID riser module, see "Installing the internal RAID riser
module" on page
299.
▶
If applicable, install the SAS expander board holder, see "Installing the SAS
expander board holder" on page 205.
Figure 72: Connecting cables to the 12x 3.5-inch HDD backplane
▶
Connect the following cables to the HDD backplane:
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 163
To Next Page
Loading...
