▶
Release all HDD modules and pull them out a few centimeters, see
"Removing 3.5-inch HDD modules" on page
153.
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD dummy module" on page
151.
Removing the defective 12x 3.5-inch HDD backplane
▶
If applicable, remove the SAS expander board holder, see "Removing the
SAS expander board holder" on page 208.
▶
Remove the internal RAID riser module, see "Removing an internal RAID
riser module" on page 303.
▶
Disconnect all cables from the HDD backplane.
Figure 70: Removing the 12x 3.5-inch HDD backplane
▶
Release the nine screws (see circles).
▶
T
ake out the HDD backplane at a slight angle.
Hard disk drive (HDD) / solid state disk (SSD)
162 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
