Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 47.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
Release all PCIe SSD modules and pull them out a few centimeters, see
"Removing 2.5-inch HDD/SSD modules" on page 180.
The PCIe SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all PCIe SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
177.
▶
"Removing the fan cage" on page 76.
Removing the defective 24x 2.5-inch HDD backplane and the switch
board
▶
Disconnect all cables from the switch board.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 199
To Next Page
Loading...
