▶
Position the HDD backplane on the six hooks (see orange circles).
▶
Push the HDD backplane downward. Make sure that the HDD backplane
and the switch board fits into the guide pins.
▶
Fasten the screws (see blue circles).
Figure 98: Connecting cables to the switch board
▶
Connect the following cables to the switch board:
1 Signal cable
2 Power cable
3 Slimline cable
4 Slimline cable
5 Power cable
6 Power cable
7 Slimline cable
8 Slimline cable
The cables are equipped with labels showing the right connector.
For the cable plan, see "Appendix B" on page
559.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 201
To Next Page
Loading...
