Note on expansion card replacement
Some FC/CNA/LAN/IB cards support adjusting the firmware version
after maintenance and replacement to the specified version. There are
cards that support matching the number of editions specified by the
customer to manage the card.
Also, check the settings before replacing some cards and reconfigure
after replacing some cards.
Follow the procedure specified separately
.
For Japan:
Follow the instructions provided separately
.
Preliminary steps
▶
"Locating the defective server" on page 47.
▶
If applicable, "Configuring LAN teaming" on page 115.
▶
"Suspending BitLocker functionality" on page 89.
▶
"Checking boot priority" on page 93.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
"Locating the defective component" on page 48.
Removing the defective expansion card
▶
Remove the expansion card, see "Removing an expansion card" on
page 278.
▶
If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see "Removing slot brackets" on page 252.
Expansion cards and backup units
282 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
