Installing the new expansion card
▶
If applicable, install the slot bracket, see "Installing slot brackets" on
page 249.
▶
Install the expansion card, see "Installing an expansion card" on page
269.
Concluding steps
▶
"Reassembling" on page 59.
▶
If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
"Enabling replaced components in the BIOS" on page 102.
▶
Inform the customer about changed WWN, MAC, GUID and SAS
addresses, see "Looking for MAC/WWN/GUID and SAS addresses" on
page 109.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Updating expansion card firmware" on page 98.
▶
"Setting boot priority" on page 120.
▶
"Resuming BitLocker functionality" on page 107.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer
. For more information, see "Notes on network settings
recovery" on page 281.
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page
115.
Expansion cards and backup units
RX2540 M7 Upgrade and Maintenance Manual 283
To Next Page
Loading...
