Figure 173: Connecting cables to the system board
▶
Connect the following cables:
1 Slim SAS cable to connector "MCIO2" on the system board
2 Slim SAS cable to connector "MCIO1" on the system board
3 Power cable to connector "PWR 1" on the system board
The cables are equipped with labels showing the right connector.
For the cable plan, see "Appendix B" on page
559.
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Expansion cards and backup units
302 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
