Figure 220: Installing the EVAC CPU heat sink
▶
Install the EV
AC CPU heat sink in the same way.
▶
Fasten the two additional screws in any order (see circles).
Torque: 0.6 Nm
Upgrading the main memory
▶
Select an adequate memory configuration for "2 CPUs populated", see
"Basic information" on page 350.
▶
Install memory modules, see "Installing memory modules" on page 341.
▶
Install dummy memory modules in empty slots, see "Installing memory
modules" on page 341.
Installing three additional fan modules
▶
Install three fan modules in bays 4, 5 and 6, see "Installing the fan module"
on page 244.
Processor (CPU)
RX2540 M7 Upgrade and Maintenance Manual 361
To Next Page
Loading...
