▶
Remove the front VGA cable from the cable clip (1).
▶
Disconnect the front VGA cable from the system board connector "FRONT
VGA" (2).
Installing the front VGA dummy cover
Figure 322: Installing the dummy cover
▶
Install the dummy cover
.
Concluding steps
▶
"Installing the air duct" on page 79.
▶
"Installing the fan cage" on page 77.
▶
If applicable, "Installing the riser module 1" on page 74.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
Front panel
RX2540 M7 Upgrade and Maintenance Manual 475
To Next Page
Loading...
