After replacing the system board the backup data is restored from the Chassis
ID EPROM to the new system board.
MAC addresses will be changed by replacing the system board. Inform
the customer about that before starting these tasks. After doing these
tasks, inform the customer about the changed MAC addresses.
Notes on network settings recovery
When replacing the system board, network configuration settings in the
OS will be lost and replaced by default values. This applies to all static
IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing the
system board.
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
"Suspending BitLocker functionality" on page 89.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
Disconnect all external cables.
▶
Remove all PSUs, see "Removing a hot-plug PSU" on page 129.
▶
If applicable, remove the OCP module, see "Removing an OCP module" on
page 265.
▶
"Getting access to the component" on page 55.
System board and components
RX2540 M7 Upgrade and Maintenance Manual 513
To Next Page
Loading...
