▶
For a system with air cooling, proceed as follows:
▶
"Removing the air duct" on page
80.
▶
Remove all memory modules, see "Removing memory modules" on
page 344.
Before removing the memory modules, take a note on the
installation slot number for each memory module. Ensure that you
reinstall the memory modules in the slot they were located before
the replacement.
▶
If applicable, remove all dummy memory modules, see "Removing a
memory dummy module" on page
347.
▶
Remove all riser modules, see "Removing a riser module" on page 72.
▶
"Removing the fan cage" on page 76.
▶
"Removing the crossbar" on page 83.
▶
If applicable, remove all expansion cards, see "Removing an expansion
card" on page 278.
▶
Remove the iRMC microSD card, see "Removing the iRMC microSD card"
on page 506.
Removing the defective system board
▶
Disconnect all cables from the system board.
System board and components
514 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
