Messages of firmware restore in SEL log files
If the firmware restore is successfully completed, the following messages will
be recorded.
–
When firmware version in iRMC microSD card and firmware version of
replaced system board is dif
ferent:
...
<iRMC>: Firmware 1 has been successfully restored from SD
card.
<iRMC>: Firmware 2 has been successfully restored from SD
card.
...
The Golden Image has been successfully restored from SD
card.
...
Chassis IDPROM: BIOS restore successful
...
BIOS TFTP or HTTP/HTTPS flash OK.
...
BIOS TFTP or HTTP/HTTPS flash OK (Recovery area)
If firmware restore fails after system board replacement, the SEL described
above is not recorded.
–
When firmware version in iRMC microSD card and firmware version of
replaced system board is same:
...
Restore of iRMC firmware 1 omitted because the already
flashed firmware has the same version
Restore of iRMC firmware 2 omitted because the already
flashed firmware has the same version
...
Restore of the Golden Image omitted because the already
flashed Golden Image has the same version
...
Chassis IDPROM: BIOS restore successful
...
BIOS TFTP or HTTP/HTTPS flash OK....
BIOS TFTP or HTTP/HTTPS flash OK (Recovery area)
System board and components
522 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
