Fujitsu PRIMERGY TX2550 M5 - Removing the Power Distribution Board

▶
Connect all cables to the power distribution board.
▶
Install the PSU into bay 2, see "Installing a hot-plug PSU" on page
147.
Concluding steps
▶
"Installing the crossbar" on page
91.
▶
If applicable, "Installing the riser module" on page 87.
▶
"Installing the PCI air duct" on page 89.
▶
"Installing the system air duct" on page 68.
▶
"Reassembling" on page 68.
▶
"Connecting the power cord" on page 82.
▶
"Switching on the server" on page 83.
▶
"Resuming BitLocker functionality" on page 130.
6.4.2 Removing the power distribution board
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
Preliminary steps
▶
"Locating the defective server" on page 47
.
▶
"Suspending BitLocker functionality" on page 107.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
▶
"Removing the system air duct" on page 67.
▶
"Removing the PCI air duct" on page 88.
Power supply unit (PSU)
158 Upgrade and Maintenance Manual TX2550 M5