▶
"Getting access to the component" on page 51
.
Removing the serial interface
▶
Remove the two bolts (see Figure 340) and take out the serial interface.
The rectangular break-out remains open.
▶
Disconnect the serial interface cable from the system board connector
"SERIAL" (see Figure 339).
Concluding steps
▶
"Reassembling" on page 68
.
▶
"Connecting the power cord" on page 82.
▶
"Switching on the server" on page 83.
15.4 Replacing the serial interface
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: hexagon screw driver 5 mm
Preliminary steps
▶
"Shutting down the server" on page 49
.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
Removing the defective serial interface
▶
Remove the serial interface, see "Removing the serial interface" on
page 526.
Serial interface
TX2550 M5 Upgrade and Maintenance Manual 527
To Next Page
Loading...
