Fujitsu PRIMERGY TX2550 M5 - Replacing the SAS Expander Board

▶
Remove the screw (see circle).
▶
Push the SAS expander board in the direction of the arrow
.
▶
Remove the SAS expander board from the SAS expander board holder.
Concluding steps
▶
Install the fan bridge, see "Handling the fan bridge" on page
92.
▶
"Installing the system air duct" on page 68.
▶
"Reassembling" on page 68.
▶
"Connecting the power cord" on page 82.
▶
"Switching on the server" on page 83.
▶
Update the system information of your server using the Chassis ID Prom
Tool, see "Using the Chassis ID Prom Tool" on page 136. Select the
corresponding system name.
▶
"Resuming BitLocker functionality" on page 130.
7.9.3 Replacing the SAS expander board
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
Replacing the SAS expander board for configuration with up to 32
HDD/SSD modules, see "Replacing the SAS expander board
(configuration with up to 32 HDD/SSD modules)" on page 258
.
Preliminary steps
▶
"Suspending BitLocker functionality" on page 107
.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
Hard disk drive (HDD) / solid state disk (SSD)
TX2550 M5 Upgrade and Maintenance Manual 313