Fujitsu PRIMERGY TX2550 M5 - Installing the Top Cover

Figure 21: Installing the rack front cover (B)
▶
Fasten the rack front cover to the chassis with two screws on either side.
▶
Insert and push the ID card into its slot until it locks in place as shown, see
Figure 7.
4.5.3.2
Installing the top cover
Note for servers with the configuration up to 32x 2.5" HDD/SSD
modules:
For this configuration the locking lever is positioned more in the middle.
It is not possible to use this top cover in other configurations.
Basic hardware procedures
70 Upgrade and Maintenance Manual TX2550 M5