Fujitsu PRIMERGY TX2550 M5 - Replacing the Ultraslim ODD in the 4 X 3.5-Inch HDD Extension Box

▶
If applicable, "Installing the riser module" on page 87
.
▶
"Installing the PCI air duct" on page 89.
▶
"Installing the system air duct" on page 68.
▶
"Reassembling" on page 68.
▶
"Connecting the power cord" on page 82.
▶
"Switching on the server" on page 83.
12.6.3 Replacing the ultraslim ODD in the 4x 3.5-inch
HDD extension box
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: – Phillips PH0 / (+) No. 0 screw driver
– Slotted screw driver (for bending in or out accessible drive
mounting brackets)
Preliminary steps
▶
"Locating the defective server" on page 47
.
▶
"Removing backup and optical disk media" on page 110.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
▶
Removing the front cover is not required in order to replace the
ultraslim ODD in the 4x 3.5-inch HDD extension box.
▶
"Removing the system air duct" on page 67.
▶
"Removing the PCI air duct" on page
88.
▶
If applicable, "Removing the riser module" on page 86.
Accessible drives
TX2550 M5 Upgrade and Maintenance Manual 453