Fujitsu PRIMERGY TX2550 M5 - Expansion Cards in Riser Modules; Installing an Expansion Card in a Riser Module

▶
"Resuming BitLocker functionality" on page 130
.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
"Note on network settings
recovery" on page 361.
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page
139.
9.7
Expansion cards in riser modules
9.7.1 Installing an expansion card in a riser module
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page 107
.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
▶
"Removing the riser module" on page 86.
▶
"Installing the riser card" on page 85.
Expansion cards and backup units
TX2550 M5 Upgrade and Maintenance Manual 363