Fujitsu PRIMERGY TX2550 M5 - Page 404

Preliminary steps
▶
"Suspending BitLocker functionality" on page 107
.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
▶
"Removing the system air duct" on page 67.
Removing a memory module
Figure 260: Removing memory modules (A)
▶
Eject the desired memory module by pressing out the securing clips at each
end of the memory slot.
Figure 261: Removing memory modules (B)
▶
Remove the ejected memory module.
▶
If applicable, install a dummy module, see "Installing a memory dummy
module" on page
406.
Concluding steps
▶
"Installing the system air duct" on page 68.
▶
"Reassembling" on page 68.
Main memory
404 Upgrade and Maintenance Manual TX2550 M5