Preliminary steps
▶
"Locating the defective server" on page 47
.
▶
"Verifying the system time settings" on page 126.
▶
"Shutting down the server" on page 49.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 51.
Replacing the defective CMOS battery
Figure 307: Replacing the CMOS battery
▶
Press the locking spring into direction of the arrow (1), so that the CMOS
battery jumps out of its socket.
▶
Remove the CMOS battery (2).
CAUTION
Sharp tools such as screw drivers might damage system board
components in case of slipping.
▶
If the CMOS battery cannot be ejected without the help of a tool,
it is recommended to use a tooth pick.
▶
Insert a new CMOS battery of the same type into the socket (3) and (4).
System board and components
TX2550 M5 Upgrade and Maintenance Manual 475
To Next Page
Loading...
