7.8 Seeing Block Waveforms
115
7
Chapter 7 Waveform Screen Monitoring and Analysis
This applies to the Memory function only.
If recorded by memory division, the usage status of blocks can be checked. Furthermore, the
desired block can be selected and the recorded waveform can be displayed.
When memory division is not used, depending on the record length, it is possible to display the last
16 measured waveforms.
See: "7.3 Moving the Waveform Display Position" ( p.106)
7.8 Seeing Block Waveforms
1
Press the DISP key to display the waveform screen.
Data trigger time of the selected block
4
Select [Pos↔Block].
The block is displayed in the upper part of the screen.
Use [Left] or [Right] to move the displayed block.
Blue blocks:
Saved blocks (blocks in use)
3
Green blocks: Currently selected displayed block
Blocks with light blue frame: Referenced blocks
Press the WAVE key.
2
When you want to overlap with other blocks (reference blocks)
Open the Status screen to the [Memory Div] sheet and set
[Ref Block] to [On]
and select [All Blks On].
See: "12.2 Display Settings" ( p.204)
To Next Page
Loading...