Hioki 8847 -  Trigger Modes and Averaging

13.2 Operation Workflow
208
13.2 Operation Workflow
Recording and
Calculation
Settings
Set FFT analysis ( p.209)
Set the input channel ( p.226)*1
Set trigger criteria ( p.151) *1
Analysis, Saving
& Printing
PrintSaveAnalyze
[Exec]
or
START key
Waveform screen
Installation & Connections
"Chapter 2 Measurement Preparations" ( p.17)
See: "13.6 Saving Analysis
Results" ( p.232)
See: "13.7 Printing Analysis
Results" (
 p.233)
See: "13.8 Analysis with the
Waveform Screen" ( p.234)
Settings for saving ( p.232) *1, *2
Settings for printing ( p.233) *1, *2
Set the screen layout of the
Waveform screen
( p.227)
Turn Power On
Finish by pressing the STOP key or automat-
ically (depending on trigger settings)
*1: Settings are the same as for the Memory function.
*2: Even after analysis, save and print settings can be set manually.
Finished Recording
Recording Starts
Measure with New Settings Measure with Existing Settings
Set as occasion demands.
Set FFT analysis ( p.209)
START key
Calculation occurs after acquiring the
waveform.
FFT calculation
Set up input channels ( p.226)*1
Set the screen layout of the
Waveform screen
( p.227)
Settings for saving ( p.232)*1, *2
Settings for printing ( p.233) *1, *2
About internal
operation
"Trigger Modes and Aver-
aging" (
 p.218)
[Status]
sheet
Set the Function to FFT ( p.209)
[Status] sheet
Channel set-
tings window,
[Each Ch]
sheet
[Status] sheet
Trigger set-
tings window
[File Save]
sheet
[Printer] sheet
Channel set-
tings window,
[Each Ch]
sheet
[File Save]
sheet
[Printer]
sheet