8.9 Copying settings to other channels (calculation No.) (Copy function)
139
8
Chapter 8 Utility Functions
At the following screens, settings can be copied to other channels and calculation No. (When the
FFT function is used).
• Channel settings window
• Display range window
• Trigger settings window
• Status screen-[Status] sheet- [Analysis] list and [Scale] list (with FFT func-
tion only)
• Status screen - [Num Calc] sheet
• Status screen-[Wave Calc] sheet
• Channel screen - [Unit List] sheet
• Channel screen - [Scaling] sheet
• Channel screen - [Comment] sheet
The procedure is explained for the Display range window.
8.9 Copying settings to other channels (calcula-
tion No.) (Copy function)
Procedure
To open the screen: Press the DISP key →Waveform screen→Press the CH.SET key→Display range window
1
Move the cursor to the copy source channel number
(calculation No.).
2
Select [Copy].
3
Move the cursor to the channel number (calculation
No.) where you want to paste the settings.
4
Select [Paste].
To copy to all channels (calculations), point the cursor
at a channel number (calculation No.) other than the
copy source and select [All Paste].
When you want to copy all the settings on the Unit list/
Scaling/Variable sheets, select the [All setting
Paste] button or [All setting All paste] button.
When channel settings are copied among different model units, the settings
other than scaling cannot be performed. (Scaling copy is available.)
To Next Page
