Specify the location of the analysis input data using
the jog and shuttle controls.
Jog
Moves the analysis starting point.
Shuttle
Scrolls the Memory waveform.
To change the number of
analysis points
The setting can be changed at the top of the Waveform screen.
The range is determined by the number of analysis points.
If the analysis range (number of points) is larger than the memory waveform as
shown below, analysis is not performed.
To analyze only a certain
portion
If [Exec] is [Single] in the setting items at the right side of the screen, only the cal-
culation range currently displayed can be calculated.
For settings other [Single], calculation points are calculated until the final data.
To stop mid-way, press the STOP key.
Analysis results are displayed on the lower graphs.
When the trigger mode is [Auto] or [Repeat], the num-
ber of analysis points up to the end of the waveform
data is analyzed, and the last data is displayed.
Memory waveforms are not printed.
Calculation range (portion in square)
Last range calculated (line portion)
Use [Exec] or press the START key to perform analysis.
8
Analysis Starting
Point
To Next Page
Loading...